Surge protective devices DC
SPD lightning protection module (surge protector) is mainly suitable for 50Hz (or 60Hz) impact flow capacity is not greater than (60 kA) electrical circuit, limit transient overvoltage amplitude, absorption, elimination, consumption or discharge of surge current energy, make the protected electrical components from an overvoltage category to another low overvoltage category, suitable for household, and similar places electrical appliances in the line induction lightning overvoltage, operating overvoltage protection role.
DownloadInstallation method and matters needing attention
(1). The connecting wire should be used with the same capacity as the power line or greater than the power line, the total length should be controlled within 0.5 meters, The shorter the wire length, the better.
(2). There must be corresponding air switches or fuses in series at the front end of the surge protector.
(3). The power supply must be disconnected during the installation.
(4). Fault judgment of the surge protector:
① The indicator window of the module is green (normal). When the module deteriorates, the indicator window should be replaced in time;
② Surge protector can be equipped with (FS) remote remote communication alarm, remote communication touch There is a constant open and one constant close, one module or multiple modules of the surge protector failure, the contact will close, send a fault alarm signal, indicating that the module failure must be replaced.
③ Always check the air switches or fuses connected in series on the line.
